Replacing An Existing Module Using The Programming Tool - Honeywell GSMX Installation And Setup Manual

GSMX Installation and Setup Guide
If this is a new installation and the city, central station, and
Registration
customer numbers have been correctly entered, the GSMX
SUCCESS
is registered and this message is displayed. The GSMX is
now in full service and available for alarm reporting to the
central station.
Possible Errors
Displayed if no response to the registration request is
Registration
received.
BAD
Timed Out
Indicates the city, central station, or customer number for
Registration
the labeled account(s) is not accepted. The ID information
BAD
was either entered in error, or the central station failed to
Pri Sub ID
pre-authorize programmed ID numbers with AlarmNet
BAD
customer service.
Displayed if this is a repair/replacement, or an error was
Registration
made in programming the Primary account information of
BAD
GSMX for an existing account. This prompt appears for 2
Pri ID –
seconds. See the Replacing an existing module using
Need PIN
the programming tool topic.

Replacing an existing module using the programming tool

This prompt appears after pressing the down arrow [↓] on
Enter PIN#
the 7720P. Enter a 4-digit alphanumeric PIN number
provided by your central station, your dealer or an
authorized AlarmNet representative.
Press the [ENTER] key.
The registration message is sent and the unit waits for
Registering
acknowledgement.
...
If the PIN is valid, the new GSMX is registered and the old
Registration
unit unregistered. Additionally, AlarmNet sends a
SUCCESS
substitution alarm to the central station.
If you entered an invalid PIN, the appropriate message is
Registration
displayed depending on which account number is being
BAD
replaced (see above for exact wording). The registration
process is repeated.
NOTE: Each attempt causes a substitution alarm to be
sent to the central station.
– 22 –