Central Station Messages - Honeywell GSMX Installation And Setup Manual

GSMX Installation and Setup Guide
[0]
Force
Server
Update?
Y/N
[ENTER] Strt Prog
Mode?
Y/N_

Central Station Messages

The following messages are sent to the Central Station by AlarmNet for the
conditions listed below.
Alarm Condition
Alarm Code
Power On / Reset E339 C08xx
(xx=device address)
ECP Supervision E355 C0000
Communication Path E350 C0951
Supervision
Test 5555 5555 9
NOTE: The control panel sends its own general code (E353) for a trouble
condition.
Force Upload of Configuration File to
Server
Pressing [Y] will force the device to upload its
entire configuration file to the server.
Pressing [N] cancels the operation.
NOTE: If the GSM module is not initialized
when you enter this command, the following
screen will be displayed:
Cannot Upload
Try Later! _
Wait for the SIGNAL (green) LED to light,
indicating the GSM module has completed its
initialization, and try again.
Enter Program Mode
Press [Y] to enter program mode; otherwise,
press [N].
ECP Mode
Restore Code Alarm Code
5551 5555 6
R355 C0000 5555 5515 5
R350 C0951 5555 5551 5
5555 5555 9
– 26 –
4204 Modes
Restore Code
5555 5535 5
5555 5553 5