Table of Contents
Advertisement
Item
Description
Message indicating what the GPS system is doing (For example,
Status
"Tracking a fix", "Searching for satellites", "Inactive")
Time of fix
This is the date and time that the last fix was taken.
Latitude
Latitude at time of last fix. (For example, "33.1349")
Longitude at time of last fix. (For example, "-117.2805")
Longitude
Altitude
Elevation at time of last fix. (For example, "40 meters")
Speed at which device was moving at time of last fix. (For example, "3.1
Speed
mph")
Direction in which device was moving at time of last fix, using 360°
Heading
compass (0 = North, 90 = East, 180 = South, 270 = West)
The number of satellites used to get the last fix.
Satellites
GPS Settings
Turns the GPS service on or off. See
Enable GPS
Note: For best results, minimize the number of obstructions between
your device and the GPS satellites.
This setting specifies whether to use metric units when displaying the
Use Metric
GPS results (for example, for altitude and speed). See
units
Units.
This setting determines how often your device should obtain a fix. See
Setting the GPS
GPS mode
Settings Page
From the Settings page, you can configure your device, network settings, and router settings.
Mingle Manager (Browser) Interface
Mode.
●
One-time – A single fix is used. Use this option if you'll be using
your device at the same location.
●
Continuous – Fixes are obtained every few seconds (also
known as auto-tracking). This is useful for turn-by-turn (TBT)
navigation applications, such as driving directions, and for
NMEA-enabled applications.
Enabling / Disabling
GPS.
Using Metric
50
Advertisement
Table of Contents
