Buffalo WAPS-APG600H User Manual page 31

Chapter 3 Configuration
Parameter
Start AOSS
Reset AOSS
AOSS Settings
Encryption
Meaning
Click the button to start the AOSS connection.
Displayed when connected by AOSS.
Click this button to disconnect the AOSS connection. This
disconnects from all connected wireless LAN devices, and the
information is changed as shown below.
AOSS Clients information: Erased.
AOSS connected device information: Erased.
AOSS Button on the AirStation
Sets whether the AOSS/WPS button on the AirStation is used.
If the button is disabled, the AOSS connection does not start even
when the AOSS/WPS button on the AirStation is pressed.
WEP Authentication
The encryption system for an AOSS device that uses the WEP
encryption level can be specified. WEP64 and WEP128 are provided
as encryption systems with 64-bit length and 128-bit length WEP
keys, respectively. If "Disabled" is specified, the WEP encryption
level is not provided.
TKIP Authentication
The encryption system for an AOSS device that uses the TKIP
encryption level can be specified. If "TKIP/AES mixed mode" is
selected, both TKIP and AES can be used for the Unicast encryption
system. (TKIP is used for the Multicast encryption system regardless
of the Unicast encryption system.)
VLAN
The VLAN ID of the device connected by AOSS can be specified.
When AOSS is started, the same VLAN as the management VLAN ID
is assigned, but this can be changed manually to any user-selected
ID.
The encryption level used by AOSS and the detailed security
information is displayed for each wireless LAN interface standard.
When the AirStation is connected to a wireless device that does not
support AOSS, set this information manually to the wireless device.
The 802.11a and 802.11g standards each have different security
information.
Encryption Type
These are the currently available encryption levels.
- 30 -