Place The Thor Vm2 In The Dock; Removing The Thor Vm2 From The Dock - Honeywell Thor VM2 User Manual

Place the Thor VM2 in the Dock

A. Notch on Thor VM2
B. Release lever
1. Locate the notch on the upper rear of the Thor VM2 (item A above).
2. Slide this notch over the top lip (C) of the Dock. Slide the Thor VM2 from side to side on the Dock to make sure it fully
engages on the lip of the Dock. If the Thor VM2 cannot be slid side to side, the lip is engaged.
3. Pull the quick release lever (B) on the Thor VM2 down and push the Thor VM2 against the Dock.
4. Release the quick release lever. The quick release lever catches the lower lip on the Dock and secures the Thor VM2 to
the Dock.
5. If necessary, adjust the viewing angle of the Thor VM2.

Removing the Thor VM2 from the Dock

The Thor VM2 may be removed from the Quick Mount for limited periods of use or the transfer from vehicle to vehicle.
The UPS battery inside the Thor VM2 powers a fully functional Thor VM2 for a minimum of 30 minutes.
To remove the Thor VM2 from the Dock:
1. Pull the quick release lever (item B) downward on the back of the Thor VM2.
2. Pull the bottom of the Thor VM2 away from the Dock.
3. Lift the Thor VM2 away from the Dock.
2-4
Back of Thor VM2 Front of Quick Mount Smart Dock
C. Upper Lip on Dock
D. Lower Lip on Dock