Linksys VONAGE PAP2 Ver. 2 Installation And Troubleshooting Manual page 38

Phone Adapter with 2 Ports for Voice-over-IP
3. You will hear, "Configuration menu. Please enter option followed by the # (pound) key or hang up to
exit."
Press 110.
4. Write down the IP address you hear, and then hang up the telephone.
3. I need to assign a static (fixed) IP address to the Phone Adapter.
There are two ways to assign a static IP address. You can use the Interactive Voice Response Menu or the
Web-based Utility.
To use the Interactive Voice Response Menu, follow these instructions:
1. Use a telephone connected to the PHONE 1 or PHONE 2 port of the Phone Adapter.
2. Press **** (in other words, press the star key four times).
3. You will hear, "Configuration menu. Please enter option followed by the # (pound) key or hang up to
exit."
Press 101 to access the DHCP feature.
4. Press 0 to disable DHCP.
5. Press 111 to set the static IP address.
6. Enter the IP address using numbers on the telephone keypad. Use the * (star) key when entering a
decimal point.
7. Press 121 to set the network or subnet mask.
8. Enter the network or subnet mask using numbers on the telephone keypad. Use the * (star) key
when entering a decimal point.
9. Press 131 to set the IP address for the gateway or router.
10. Enter the IP address using numbers on the telephone keypad. Use the * (star) key when entering a
decimal point.
11. Hang up the telephone.
30
Appendix A: Troubleshooting
Common Problems and Solutions