Bottom Panel; Power - Honeywell Dolphin 70e Black User Manual

RJ45 Ethernet Port
Use a standard CAT-5 Ethernet cable; you can connect the ebase to an Ethernet-compliant
device to facilitate Ethernet communication to and from the terminal. The RJ45 connector
includes integrated LEDs that provide Ethernet communication status and speed information.
Status
No Ethernet Link
10Mbps Ethernet Connection Established
100Mbps Ethernet Connection Established
Data transfer in progress
DC Power Jack
See

Power

Bottom Panel

For details on how to mount the eBase, see
Compliance Label
Power
The base requires 12 Volts DC input for communications, battery charging, and power output to the
terminal; the power adapter included with the base converts the voltage from the AC power source to
12 Volts DC. Use only a UL listed power supply, which has been qualified by Honeywell with
output rated at 12VDC and 3 amps with the device. The operating temperature range is -10° to 50°C
(14° to 122°F). Honeywell recommends that you leave the eBase connected to its power source at all
times, so that it is always ready to use.
We recommend use of Honeywell peripherals, power cables, and power adapters. Use of any non-Honeywell
peripherals, cables, or power adapters may cause damage not covered by the warranty.
on page 12-5.
Yellow LED
Off
Off
On
Connection Speed Dependent
(see above)
Mounting the eBase on page
Green LED
Off
On
On
Flashing
12-8.
Serial Number Label
MAC Address Label
12 - 5