Installing A 5800Tm Module; Installing The Transmitters - Honeywell ADEMCO VISTA-12A Installation And Setup Manual

Installing a 5800TM Module

1. Mount the 5800TM next to the RF receiver
(between one and two feet from the receiver's
antennas) using its accompanying mounting
bracket. Do not install within the control
cabinet.
2. Connect the 5800TM to the control panel's
keypad connection terminals as shown on the
Summary of Connections diagram and set to
address 28.

Installing the Transmitters

1. To be sure reception of the transmitter's signal
at the proposed mounting location is adequate,
perform a Go/No Go Test (see the Testing the
System section).
2. Install transmitters in accordance with the
instructions provided with each.
3. Set 5827, 5827BD, 5804BD wireless keypads to
the programmed House ID (field *24), using its
DIP switches (5827) or follow the instructions
provided with the device.
Transmitter Battery Life
• See Wireless Transmitter paragraph in the Limitations of This Alarm System statement located
at the end of this manual for information on transmitter battery life.
• Some transmitters (e.g., 5802 and 5802CP) contain long-life but non-replaceable batteries, and
no battery installation is required. At the end of their life, the complete unit must be replaced
(and a new serial number enrolled by the control).
• Button-type transmitters (such as 5801, 5802, and 5802CP) should be periodically tested for
battery life.
• The 5802MN, 5802MN2, and 5804 Button Transmitters have replaceable batteries.
Do not install batteries in wireless transmitters until you are ready to enroll during system
programming. After enrolling, batteries need not be removed.
Mounting and Wiring the Control
Notes
•
Use this module only in 345Hz RF
systems and if you are using one or more
wireless bi-directional keypads or keyfob;
5800TM is not necessary if using a
Transceiver (e.g., 5883).
•
The 5800TM must be set to address 28
(cut red-W1 jumper).
•
The 5800TM can be used in partition 1
only.
•
For additional information regarding the
5800TM, refer to the 5800TM's
instructions.
Notes
•
Refer to the table of compatible devices at
the back of this manual.
•
Supervised transmitters
signals to the receiver at 70-90 minute
intervals. If at least one check-in message
is not received from each transmitter
within a 12-hour period, the "missing"
transmitter number(s) and "CHECK" is
displayed.
†
Hand-held transmitters (e.g., 5802, 5802CP, 5804,
5804BD, 5827, 5827BD) do not send check-in
signals.
†
send check-in
2-13