Remote Protocol Setup; Figure 3-9 Remote Screen - Honeywell HRTL-One User Manual

Remote Protocol Setup

Rev 1.00
You can control the HRTL-One remotely using commands specified in
Remote screen you configure:
• Remote protocol interface
• Transmission baudrate
• Remote protocol ID
1. On the Main Menu screen, press
The following screen appears:
Figure 3-9 Remote Screen
(Menu)
Timer
Record
Alarm
Remote
System
Event
2. Press or to select the Remote Mode field, then press Enter.
Press or to choose from the following options:
RS-232 = RS-232 interface
RS-485 = RS-485 interface
Press Menu to confirm your changes.
3. Press or to select the Baud Rate field, then press Enter.
Press or to choose from the following options:
115200, 57600, 19200, 9600, 4800, 3600, 2400, 1200
Press Menu to confirm your changes.
4. Press or to select the ID field, then press Enter.
Press or to set the numerical number and press
digit (3 digits).
Press Menu to confirm your changes.
5. Press Menu to exit this screen and confirm the current operations.
6. If you have completed all your system configuration changes, press Menu again to
exit and close menu setup.
HRTL-One Digital Video Recorder User Guide
or to select Remote, then press Enter.
Remote Mode: RS-232
Baud Rate: 9600
ID: 000
29
Table 3-6. On the
(Remote)
or to move to the next
Document 900.0259
10/04