Alarm Mode Setup; Figure 3-8 Alarm Screen - Honeywell HRTL-One User Manual

Alarm Mode Setup

Rev 1.00
Press Menu to confirm your changes.
3. Press or to select the Record Quality field, then press Enter.
Press or to choose from the following options:
See Table 3-2 (NTSC) or
duration vs. the quality selected.
Press Menu to confirm your changes.
4. Press or to select the Record Mode field, then press Enter.
Press or to choose from the following options:
Fields, Frames
Press Menu to confirm your changes.
5. Press Menu to exit this screen and confirm the current operations.
6. If you have completed all your system configuration changes, press Menu again to
exit and close menu setup.
Use the Alarm screen to set how the system responds to an alarm event (for example,
video loss, power failure, full hard drive).
1. On the Main Menu screen, press
following screen appears:
Figure 3-8 Alarm Screen
(Menu)
Timer
Record
Alarm
Remote
System
Event
2. Press or to select the Alarm Enable field, then press Enter.
Press or to choose from the following options:
Yes = Turns on the alarm and activates a steady alarm LED on the front panel.
When the HRTL-One detects an alarm condition, the appropriate LED on the
front panel flashes to alert the user.
HRTL-One Digital Video Recorder User Guide
Table 3-3 (PAL) as a guide to determine the record
or to select Alarm, then press Enter. The
Alarm Enable: Yes
Alarm Duration: 1 MIN
Record IPS: 60
Quality: High
Record Mode: Frame
27
(Alarm)
Document 900.0259
10/04