Table of Contents
Advertisement
System Setup
Control
Function (cont'd)
7. REC
Press to start recording.
8. POWER
Press to power up the HRTL-One. Press again to power off the HRTL-One.
9. REW
Press once to play video backward at high speed. Press again to adjust the speed (1, 2, 4, 8, 16, 32
(Left)
times, depending on the number of times you press this button).
10. FF
Press once to play video forward at high speed. Press again to adjust the speed (1, 2, 4, 8, 16, 32
(Right)
times, depending on the number of times you press this button).
11. PAUSE
Press to pause the video at the currently displayed image.
12. PLAY
Press to play recorded video.
13. LEDs
Under the following conditions, the red light is ON:
•
HDD = The hard drive is activated.
•
HDD FULL = The hard drive is full.
•
ALARM = When alarm enable is set to Yes and an alarm is triggered, the LED flashes red.
•
TIMER = When the recording timer is set for operation.
•
PLAY = The HRTL-One is in Play mode.
•
REC = The HRTL-One is in Record mode.
Recording Times
Rev 1.00
Table 3-1
Front Panel Controls
The record time depends on the record speed and record quality settings (see
Setup, page 26).
Table 3-2
provides typical NTSC recording times and
typical PAL recording times for a 120 GB hard drive.
recording times and
Table 3-5
drive.
Table 3-4
provides typical PAL recording times for a 250 GB hard
16
Recording
Table 3-3
provides
provides typical NTSC
Document 900.0259
10/04
Advertisement
Table of Contents
