Figure 3.6 Selecting Video Input 3 To Channel 1 - Honeywell MAXPRO-Net Commissioning Manual

3.4 COMBINING, CONTINUED
Example Of Selecting Video Inputs
The following is an example of video input 3 being selected onto monitor 1, which is
connected to channel 1 of the combiner subrack.
If monitor 1 selects video input 3, the MAXPRO-Net Server selects every video-switching
module in channel 1 (highlighted in figure 3.6) of the pre-selection subracks (A, B and
C).
Video input 3 is located on pre-selection subrack A. Therefore, the video switching
module in channel 1 of pre-selection subrack A gets instructed by the System Controller
to select the desired video input, and put it on its output (1A).
When selecting video inputs (1
the A input. If video inputs (33
subrack would access the B input. Similarly, video inputs (65
through the C input of the combiner subrack.
Rev. B

Figure 3.6 Selecting Video Input 3 To Channel 1

32), all channels in the combiner subrack would select
64) are selected, the channels in the combiner
3-8
96) are selected
HMXMC001013
31-Mar-06