Adjustment
220 to 240V specification
[Standard]
The belt slack should be 4.6 to 6 mm when pushing the center of the motor belt between
the T pulley of the upper shaft and the T pulley of the motor with a force of 0.98 N (100g).
[Adjustment]
1. Turn off the power, and then remove the foot controller.
2. Remove the face plate and the pattern selection dial, and remove the front cover and
the rear cover.
3. Loosen the 2 screws 1 of the motor holder.
4. Move the motor holder up and down to adjust the tension of the motor belt.
5. Tighten the 2 screws 1 of the motor holder to secure the motor holder to the arm bed.
1
XC2277001
Push-pull gauge
Motor belt tension
BOLT.
(S/P WASHER)
M5X12
Push-pull gauge (5N)
Motor belt tension
0.98 N (100g)
4 - 7
4.6 - 6 mm
Motor holder
<In case of 120V specification, refer to previous page.>
Motor belt
1