Table of Contents
Advertisement
1
2
1. Clamp
2. Cover (A)
1
2
1. Cover (B)
2. Screw
1. Limit mark
2
1
1. Brush holder cap
2. Screwdriver
8
Cleaning covers
005174
When accumulation of dust on the cover (A) looks excessive, loosen the clamp
and remove the cover (A). Wash off accumulation of dust inside the cover (A)
and wipe it. Then install the cover (A) on the tool so that its side with "Upside
" mark faces upward. Push the cover (A) toward the motor as far as it will go
and secure it by tightening the clamp.
When changing the wheel, clean the cover (B) at the same time. Loosen the
005175
screw securing the cover (B) and remove the cover (B). Wash off accumulation
of dust inside the cover (B) and wipe it. Then attach the cover (B) to the tool by
tightening the screw. Accumulation of dust inside the covers may cause a mal-
function of the tool.
CAUTION:
•
When using the tool, be sure to attach the covers (A) and (B).
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly. Replace when they wear
down to the limit mark. Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the same time. Use only
identical carbon brushes.
First, remove the cover (A).
1
Use a screwdriver to remove the brush holder caps. Take out the worn carbon
005176
brushes, insert the new ones and secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs, any other mainte-
nance or adjustment should be performed by Makita Authorized Service Cent-
ers, always using Makita replacement parts.
Advertisement
Table of Contents
