Table of Contents
Advertisement
2
1
25
25.4
25
3
1. Mounting shaft
2. Inner flange
3. 25.4 mm marking
4. Diamond wheel
5. Outer flange
6. Hex bolt
1
1. Water cock
OPERATION
MAINTENANCE
The inner flange has a 25 mm diameter on one side and 25.4 mm diameter on
005171
the other. The side with 25.4 mm diameter is marked by "25.4". Use the cor-
rect side for the hole diameter of the wheel you intend to use. Mounting the
6
wheel on the wrong side can result in dangerous vibration.
5
4
Water flow
005172
Attach the vinyl tube onto the water pipe and attach the adapter on the vinyl
tube to a faucet of water mains pressure. Adjust the amount of water flow by
simply adjusting the water cock.
CAUTION:
•
Adjust the water cock so that the water flow rate does not exceed 1.2
liters per minute.
Adjust the amount of water flow. Hold the tool firmly. Set the base plate on the
005173
workpiece to be cut without the wheel making any contact. Then turn the tool
on and wait until the wheel attains full speed. Now simply move the tool for-
ward over the workpiece surface, keeping it flat and advancing smoothly until
the cutting is completed. Keep your cutting line straight and your speed of
advance uniform.
CAUTION:
•
THIS TOOL SHOULD ONLY BE USED ON HORIZONTAL SURFACES.
•
Be sure to move the tool forward in a straight line and gently. Forcing
and exerting excessive pressure or allowing the wheel to bend, pinch or
twist in the cut can cause overheating of the motor and dangerous
kickback of the tool.
CAUTION:
•
Always be sure that the tool is switched off and unplugged before
attempting to perform inspection or maintenance.
After use
Blow away dust from the inside of the tool by running the tool at an idle for a
while. Brush off accumulation of dust on the base. Accumulation of dust in the
motor or on the base may cause a malfunction of the tool.
7
Advertisement
Table of Contents
