Table of Contents
Advertisement
1
1. Switch trigger
ASSEMBLY
1
2
1. Offset wrench
2. Socket wrench
2
1
3
4
1. Hex bolt
2. Diamond wheel
3. Outer flange
4. Inner flange
6
Switch action
005167
CAUTION:
•
Before plugging in the tool, always check to see that the switch trigger
actuates properly and returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release the switch trigger to
stop.
CAUTION:
•
Always be sure that the tool is switched off and unplugged before
carrying out any work on the tool.
Installing or removing diamond wheel
005169
Hold the outer flange with the offset wrench and loosen the hex bolt counter-
clockwise with the socket wrench. Then remove the hex bolt, outer flange and
diamond wheel.
To install the wheel, follow the removal procedure in reverse. Always install
005170
the wheel so that the arrow on the wheel points in the same direction as the
arrow on the blade case.
BE SURE TO TIGHTEN THE HEX BOLT SECURELY.
CAUTION:
•
Use only the Makita wrench to install or remove the wheel.
Advertisement
Table of Contents
