Table of Contents
Advertisement
SPECIFICATIONS
Max. cutting capacities
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the tool. Be
sure that you understand their meaning before use.
...................Read instruction manual.
..................The tool should be used on horizon-
tal surfaces.
..................Do not use the tool upside down.
...............The tool should be used with the
PRCD (Portable Residual Current
Device).
..................Do not use the abrasive cut-off
wheel.
.................After use, brush off accumulation of
dust on the base.
.................Do not use the saw blade.
2
Model
Wheel diameter
-1
)
Overall length
Net weight
Safety Class
END104-1
Intended use
The tool is intended for cutting in brick, concrete and
stone with the use of water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. This
tool should be grounded while in use to protect the oper-
ator from electric shock. Use only three-wire extension
cords which have three-prong grounding-type plugs and
three-pole receptacles which accept the tool's plug.
4107RH
180 mm
60 mm
5,000
370 mm
7.2 kg
Class I
Advertisement
Table of Contents
