Table of Contents
Advertisement
FUNCTIONAL
DESCRIPTION
1
1. TEST button
2. "RESET" or "ON" button
3. Pilot lamp
4. Portable residual current
device(PRCD)
1. Lever
1. Notch
CAUTION:
•
Always be sure that the tool is switched off and unplugged before
adjusting or checking function on the tool.
Portable residual current device
005151
Connect the tool to a power supply and test the Portable Residual Current
3
2
Device (PRCD) before using the tool. Push the "RESET" or "ON" button and
confirm that the pilot lamp lights. Push the "TEST" button and confirm that the
pilot lamp goes out. Push the "RESET" or "ON" button again to use the tool.
WARNING:
•
Do not use the tool if the pilot lamp does not go out when the "TEST"
4
button is pushed.
Adjusting the depth of cut
005165
Loosen the lever on the depth guide and move the base up or down. At the
desired depth of cut, secure the base by tightening the lever.
CAUTION:
•
After adjusting the depth of cut, always tighten the lever securely.
1
Sighting
005166
Align the notch in the front of the base with your cutting line on the workpiece.
1
5
Advertisement
Table of Contents
