Honeywell Mercury User Manual page 45

Modem Configuration (WINDOWS)
Command Buttons
Load: The Load function allows the user to load previously Saved
setups. These setups can be used as a starting point for any modem
configuration. The user can select any file that had been previously
saved.
Save: The Save function allows the user to save setups for later use
in other Mercury Modems. The default directory for the files is "
MERCURY\MODEMCFG\CFGFILES " with the extension ".CFG".
Read: The Read function reads the current modem configuration
from the modem's E Prom.
2
Write: The Write function loads the user selected configuration into
the modem.
Print: The Print function generates a report of the current modem
configuration. This report contains the information on the screen by
groups; Modem Identification, Dialing Speed, Modem Timing and
Alarm Setup.
Defaults: The Default function restores the modem settings to the
factory defaults. After the default command is sent, a read command
is automatically used to display the default values. The Modem ID and
the Call-In Phone Number are exceptions to the default command and
are not altered.
Clear: With the modem configuration cable connected, this button
allows the user to reset all alarm channels in the modem. This can be
used in the field if an alarm is accidentally triggered during installation.
Exit: This button is used to exit the Modem Configuration application.
Page 45
45