Honeywell Mercury User Manual page 29

Then use the PIF EDITOR in the Main Group, click on File, then click
on Open. Select the C:\MERCURY\MIMODEM\CFGMODEM.PIF.
Then change the Program Filename to the M?.BAT that matches the
COM port that you will be using. Select File from the menu line and
save the PIF, then click on exit and you are ready to start the program.
Modem Configuration Program (DOS)
The main screen will appear and the Modem Firmware Version will
be displayed. Press the F3 key to read the modem that you are
connected to.
Modem Configuration Program V1.10
Modem Firmware......: V2.10
Modem ID............:
Call-In Phone Number:
Dialing Setup
Type (Pulse or Tone): Pulse
Dialing Speed.......:
Auto Answer After...:
Number of Retries...:
Modem Timing
Wait for Dial Tone..:
Wait for Carrier....:
Comma Delay.........:
No Activity Time-out.:
Alarms Setup
Battery Low Enable..: Y
Alarm Call-In Enable: Y
<F1-Load Setup> <F3-Read Modem>
<F2-Save Setup> <F4-Setup Modem> <F6-Factory Defaults> <F10-EXIT>
Tue Sep 24 07:55:50
(P,T)
milliseconds (50 - 255)
Rings (1 - 255 or 0=NO ANSWER)
(0 - 254)
seconds
seconds
seconds
minutes
(Y, N)
(Y, N)
<F5-Print Setup>
The Main Screen
Figure 12
1996
(2 - 255)
(1 - 255)
(1 - 255)
(1 - 30 or 0=DISABLE)
Page 29
29