Verification - Honeywell Mercury User Manual

Verification (DOS)
To verify that the installation of the integral modem was successful
and the instrument is working properly, obtain a modem link with
the instrument using ER-Link or AT-Link DOS software package.
Start either the AT-Link or ER-Link (depending on the type of unit the
modem was installed in). Select Computer on the main menu line
and press Enter.
With Computer Communication highlighted, press Enter. Insure
that the Modem Baud Rate is set for 2400 baud. Check to see if the
correct Modem Port is selected and that it matches the port on the
computer.
Next move to the Transfer selection on the main menu line and press
Enter. Select Modem Link from the sub-menu options and press
Enter. Enter the Site Phone Number and press Enter.
If the modem was installed correctly, the NOT LINKED message
located in the lower left-hand corner of the computer screen will
change to MODEM LINK.
Verification (Windows)
To verify that the installation of the integral modem was successful
and the instrument is working properly, obtain a modem link with
the instrument using ER-Link or AT-Link for Windows software
package.
Start either the AT-Link or ER-Link (depending on the type of unit the
modem was installed in). Select Setup on the main menu line, then
click on Site List.
Page 17
17