Sending A Fax Automatically - Dell 2335dn Multifunctional Laser Printer User Manual

Mode
Standard
Fine
printed using a dot-matrix printer.
Super
Fine enabled only if the remote printer also supports the Super Fine resolution.
See the notes below.
Photo
Color
remote printer supports color fax reception and you send the fax
manually. In this mode, the memory transmission is not available.
NOTE: Faxes scanned in Super Fine resolution will transmit at the highest resolution
supported by the receiving device.

Sending a Fax Automatically

1. Load the document(s) face up with top edge in first into the DADF (Duplex Automatic Document
Feeder).
OR
Place a single document face down on the document glass.
For details about loading a document, see "Adjusting the Document Contrast" .
2. Adjust the document contrast and resolution to suit your fax needs.
3. Press Scroll ( or
4. Enter the remote fax phone number using the number keypad.
You can use one, two or three-digit speed or group dial numbers. For details, see "Automatic Dialing" .
5. Press Start (
6. When the document is loaded from the document glass, the display shows Another Page? on the top
line after the document is scanned into the memory. If you have additional pages, remove the scanned
page and load the next page from the glass and select Yes . Repeat as necessary.
After all of the pages are scanned, select No when the display shows Another Page?
7. When the printer establishes contact with the receiving machine, it dials the number and sends the fax.
NOTE: Press Cancel (
the fax.
Recommended for:
Documents with normal sized characters.
Documents containing small characters or thin lines or documents
Documents containing extremely fine detail. The super fine mode is
Documents containing shades of gray or photographs.
Documents with colors. Sending a color fax is enabled only if the
) to highlight Fax .
).
) to cancel the fax job at any time while sending