Identifying The Cts Satellite Endpoints; Enabling The Satellite Feature - Cisco CTS 1000 - TelePresence System 1000 Video Conferencing Administration Manual

Identifying the CTS Satellite Endpoints

Identifying the CTS Satellite Endpoints
After you have loaded the satellite license on Cisco Unified CM, identify the CTS satellite endpoints so
that they can retrieve the satellite licenses.
To identify the CTS satellite endpoints using the Cisco Unified CM administration interface:
Step 1 Log in to the Cisco Unified CM Administration page.
Step 2 From the Device drop-down menu, select Phone.
Step 3 Using the Find search fields, locate the CTS that will be used as a satellite endpoint.
Step 4 Click Reset to bring up a new dialog box, and then click Restart.
Step 5 Repeat Step

Enabling the Satellite Feature

After the satellite license has been loaded on Cisco Unified CM, and the CTS satellite endpoints have
been identified, you are ready to enable the satellite feature using CTS command-line interface (CLI)
commands. For information about using CTS CLI commands, see the
Command-Line Interface Reference
To enable the satellite feature:
Check to see that the satellite license is available. From the CTS CLI admin command prompt, enter the
Step 1
following command:
Enable the satellite feature using the following command:
Step 2
Step 3 Restart the calling services using the following command:
Cisco TelePresence System Administration Guide
A-4
2 through Step 4 for each CTS satellite endpoint.
admin:show license status
License feature status
satellite:
Valid license found
License feature is disabled
Feature is currently not running
admin:set license satellite enable
License for satellite feature changed to enabled
admin:utils service restart Calling
Calling_Services Restarting...done
Appendix A Satellite Licenses for the Cisco TelePresence System
Guide.
Cisco TelePresence System
OL-21845-01