Chapter 6
Troubleshooting the CTS 1000
c.
Saving Your Settings
When you have configured all your settings:
Click Apply to register new or modified settings.
Step 1
Click Reset to restore the original settings.
Step 2
For more information about testing and troubleshooting the CTS 1000, see the
section in the
Attaching the Camera Hood
To attach the camera hood:
Be very careful attaching the camera hood so as not to affect the focus or alignment of the camera.
Caution
Carefully fit the hood lightly over the camera without bumping the camera.
Step 1
Step 2
Align the two screw holes align in the bottom of the hood with threaded holes in the camera support
bracket and secure with two M4 x 10 mm screws.
Understanding Camera Setup Choices for Room Lighting
If your room has windows that contribute a significant amount of natural light, you can set your CTS to
automatically compensate for variable lighting conditions. This compensation is an average adjustment
and will not be as accurate as the color settings you select for a room that uses fixed, artificial room
lighting.
Table 6-2
display and camera. See the
Table 6-2
Physical Room Configuration
No windows
•
•
•
•
•
OL-21845-01
Lean backward away from the table.
Cisco TelePresence 1000 Assembly, Use & Care, and Field-Replacement Unit
contains recommendations for desirable display and camera settings when you set up the
"Testing the CTS 1000 Camera" section on page 6-7
Room Configuration and Camera Setup Choices
One window
Two adjacent windows (corner office
configuration)
Two opposing windows
Windows on three sides
Windows on four sides
Managing CTS 1000 Hardware Setup
Camera Auto Brightness and
Camera Auto Color Balance Setup Choices
Disable
Enable
Cisco TelePresence System Administration Guide
Setting Up the Camera
Guide.
for more information.
6-17