Inventory - Grizzly G0733 Owner's Manual

inventory

inventory
after all the parts have been removed from the
shipping containers, you should have the follow-
ing items:
inventory: (figures 3–6)
A. lathe assembly
—headstock (mounted) ............................. 1
—tool rest Base (mounted) ...................... 1
—tailstock (mounted) ................................. 1
—Faceplate 6" (installed) ........................... 1
b. stand legs ................................................. 2
c. machine Feet .............................................. 4
D. tool rest .................................................... 1
E. live Center mt#2 ....................................... 1
f.
spur Center mt#2 ...................................... 1
G. indexing pin ................................................ 1
H. hex Wrenches 3, 4, 6, 8mm ..................1 ea
i.
Knockout tool ............................................. 1
J. storage Basket ........................................... 1
K. hardware (not shown)
—Cap screws m8-1.25 x 35 .................... 10
—lock Washers 8mm .............................. 10
—hex Nuts m8-1.25 ................................... 2
a
figure 3. lathe assembly.
NOTICE
Some hardware/fasteners on the inventory
list may arrive pre-installed. check mount-
ing locations before assuming that any
items from the inventory list are missing.
Model G0733 (Mfg. Since 10/11)
Qty
C
figure 5. loose inventory components.
if any nonproprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
B
figure 4. stand legs.
e
F
d
i
J
figure 6. storage basket.
g
h
-13-