Basic Controls - Grizzly G0733 Owner's Manual

7.
verifies the pulley ratio is set for the appro-
priate speed range for the operation, type of
wood, and size of workpiece installed.
8. verifies the spindle direction switch is in the
"o" position and the spindle speed dial is
turned all the way counterclockwise so the
spindle does not start turning at high speed.
9. ties back loose hair and clothing, and puts
on face shield and respirator. takes all other
required safety precautions.
10. starts the lathe and dust collector, adjusts the
spindle direction and lathe speed, and care-
fully begins the turning operation, keeping the
chisel against the tool rest the entire time it is
cutting.
-20-

basic controls

refer to figure 17 and the list below to famil-
iarize yourself with the lathe controls. you will
find that understanding the names and descrip-
tions of the controls is useful when reading this
OpERATiONS section.
a
d
figure 17. Control panel and RPM Readout.
A. Spindle RpM Readout: indicates the spindle
speed in rpm (rotations per minute).
b. Spindle Direction Switch: toggles the spin-
dle direction between clockwise or counter-
clockwise.
c. Speed control Knob: adjusts the spindle
speed from low to high within the range gov-
erned by the pulley belt position.
D. ON/Off Switch
button: turns the lathe oN and oFF.
Model G0733 (Mfg. Since 10/11)
B
C
w/Emergency STOp