Power Connection; Connecting Power; Disconnecting Power - Grizzly G0733 Owner's Manual

7.
place the level on the lathe bed and make
necessary adjustments so that the bed is
level from side-to-side and front-to-back.
—if you are using the machine feet, adjust
the top and bottom hex nuts on each leg to
level the bed; then tighten the hex nuts to
secure these adjustments.
—if you are bolting your lathe to the floor, use
shims under the legs to level the bed; then
tighten the mounting fasteners.
8.
insert the tool rest into the tool rest base and
tighten the tool rest lock handle, as shown in
figure 13.
tool rest Base
figure 13. tool rest installed on the tool rest
base.
9.
attach the storage basket to the leg using
the remaining (2) m8-1.25 x 35 cap screws,
(2) 8mm lock washers, and (2) m8-1.25 hex
nuts, as shown in figure 14.
leg
figure 14. attaching basket to leg.
Model G0733 (Mfg. Since 10/11)
tool rest
tool rest
lock handle
Basket

power connection

After you have completed all previous setup
instructions and circuit requirements, the machine
is ready to be connected to the power supply.
To avoid unexpected startups or property dam-
age, use the following steps whenever connecting
or disconnecting the machine.

connecting power

1. Turn the machine power switch OFF.
2. Insert the power cord plug into a matching
power supply receptacle. The machine is
now connected to the power source.
figure 15. Connecting power.

Disconnecting power

1. Turn the machine power switch OFF.
2. Grasp the molded plug and pull it completely
out of the receptacle. Do not pull by the cord
as this may damage the wires inside.
figure 16. Disconnecting power.
-17-