Table of Contents
Advertisement
Multi-motion
image can be used to isolate a moving subject
within a series of multiple images and place them against a
stationary background.
Use a tripod or some other means to
make sure that the camera is not moving or shaking when
shooting with Multi-motion
image.
_
asic
Multi-motion
image
Procedure
1.
In the REC mode, press [BS].
2.
Select
"Multi-motion
Image"
and then press [SET].
3.
Hold down the shutter
button to record.
4.
Release
the shutter button.
Continuous
Shutter shooting will stop and the resulting composite image will
appear on the monitor screen.
• The above procedure shoots multiple images and combines them
automatically
into a final image. Do not move the camera until shooting is
complete.
• You can configure the maximum number of CS shots, the CS fps, and
Prerecord CS shots settings the same way as you configure the High Speed
CS setting (page 58). Note, however, that the maximum number of CS shots
for "Multi-motion
Image" is 28 instead of 30.
_NOTE
• The current mode dial setting is ignored when recording with this BEST SHOT
scene.
• With this BEST SHOT scene, the flash setting automatically
becomes _
(Flash
Off).
• Shooting with this BEST SHOT scene makes the shooting range narrower than
normal.
• The Self-timer cannot be used with this BEST SHOT scene.
• Shooting with "Multi-motion
Image" assumes that the subject is moving and
changing positions. Trying to use it to shoot a subject that is moving while
maintaining the same location (such as a golf swing, a baseball swing, etc.) will
cause an error message to appear on the monitor screen and failure of image
recording, or will produce an image in which the shots of the subject are arranged
incorrectly.
81
Using BEST SHOT
Advertisement
Table of Contents
