Table of Contents
Advertisement
.
Press _uP (Flash
up) to open the
flash unit.
• The flash will not fire if the flash unit
is not open.
2.
In the REC mode, press [V] ( _ { )
once.
3. Use [,]
and [,] to select the
_up (Flash
up)
IV]
( _ { )
flash setting you want and then press [SET].
Flash fires automatically
in accordance with exposure
(amount of light and brightness) conditions.
Flash does not fire.
;
i [:
Flash always fires. This setting can be used to brighten a
subject that normally comes out dark due to daylight or
backlight (daylight synchro flash).
Flash fires automatically.
This type of flash can be used to
reduce the chance of redness in the subject's eyes.
4.
Press the shutter button to shoot.
Back lamp
Flashes
red while
the flash is charging
to indicate that
image recording
is disabled.
--
[]
indicates
the flash will fire.
• Note that the flash unit does not close automatically. After
you are finished using it, you need to close it by hand.
• For information
about Flash Range, see page 188.
46
Snapshot Tutorial
Advertisement
Table of Contents
