Casio DT-800RF Supported Equipment Manual page 45

Message
Error receiving host\nlist from Server;
Unexpected Server\ndata received;
Error starting\nhost application;
Select Host or App;
Connecting...;
TCP Error\nReading IP
Address\nREBOOT MOBILE UNIT;
Printer start error;
Battery too low\nto print;
Paper Feed Error\nFix Then Hit Enter;
Printer Error\nPrint Ended;
•
Supported Equipment Manual March, 2006
Reason
Bad Protocol detected.
Bad Protocol detected.
Connected to the server but can
not connect to the distant end.
Need to choose your
Host/application destination.
Attempting to connect to the
Host/application.
Mobile Unit missing Network IP
information.
Could not initialize the printer.
Not enough power to print.
Paper in the printer is not ready.
Can not print.
Solution
Usually a result of bad cabling, power or
faulty transceiver. Also, will receive this if
the Mobile Unit is in the wrong mode for
server operation.
Usually a result of bad cabling, power or
faulty transceiver. Also, will receive this if
the Mobile Unit is in the wrong mode for
server operation.
Configure the server handler to access the
host application.
User selection required.
Advisory message.
Configure the Mobile Unit with the correct
network IP information.
Cable or power issue with the printer.
Replace the battery with a fully recharged
battery.
Replace the paper or rethread the paper in
the printer.
Check cable, battery, communication
settings and paper in the printer.
Error Message Resolution Guide
Reference Tech Note
---
---
---
---
---
---
---
---
---
---
4-5