Starting A Telnet Session - Casio DT-800RF Supported Equipment Manual

3. Press the
4. Select
5. Press the
6. Select
7. Enter
8. Select
9. Press the
10. Select
11. Select
The terminal is now configured to accept a download from Twin Client Manager.

Starting a Telnet Session

At the Twin Client main menu on the terminal, press any key to establish the connection.
Until the terminal has been authorized, the following screen is displayed.
RECOVERABLE ERROR
Terminal not
Authorized for
Twin Client
Keypress to Continue
It is not necessary to authorize the terminal at this time, so press any key to continue. The
terminal will establish a connection with the host system and start emulation. If the
terminal fails to connect to the host, refer to the following table for the possible causes
and the related corrective actions.
Failure Cause
Incorrect Host IP address
Incorrect netmask value
After a Telnet session has been successfully established, the terminal will remain in
session for a maximum of 30 minutes at a time until it has been authorized. Once
authorized, there is no software restriction on the session time. The instructions for
authorizing the terminal are presented in Authorizing PowerNet.
Supported Equipment Manual
key.
Clear
1: yes.
key to return to the system menu.
Clear
,
4: Transmit 4: Utility
and then press the
640 Enter
to change the size.
yes
key to return to the system menu.
Clear
1: Execute AP.
for "yes" to execute the AP.
Enter
Corrective Action
Correct the Host List address on the terminal. Refer to
Terminal Setup Using Twin Client Menus under Standard
Setup for instructions.
Access Radio Setup menu and correct the netmask value.
Refer to Terminal Setup Using Twin Client Menus for
instructions.
•
March, 2006
and
4: Change memory size.
key.
Quick Start
2-11