Introduction; System Overview - AEG ARE I2 Installation Manual

Manual
Page 5 / 33- Revision 01
ARE I2 / RS 232 – Installation Guide
1

Introduction

This document will describe the components of the Compact Reader System ARE I2 / RS 232
and the procedure how to do the first set up of the reader.
The main features of the reader are listed below:
• the antenna is placed inside of the housing (base version)
• there are algorithm available to read nearly all 125 kHz-transponders on market
• the serial RS 232-Interface is placed inside of the housing, allowed baud rate are up to
19200 Bit/s
• the allowed supply voltage is 9 to 30V
• low power consumption of reader < 1.2 Watt
• high reliability for reading and writing within an industrial environment.
• compact housing of the reader with multiple ways for mounting.
• the cabling concept of the reader is optimised to service demands.
• the protection class of the housing is IP65
• there is a set of external antennas available to meet special application demands ( X-tended
version)
2

System Overview

In the base version all electronic components of the reader is placed inside of a small plastic
housing.
Transponder
Figure 2-1: Concept of the Reading System
DC
Reader with
Integrated Antenna
ARE I2
24V
DC
RS232
(9-Pin SubD)
AEG
Identifikationssysteme GmbH
Söflinger Straße 100
D-89077 Ulm
Tel. ++49(0)731-933-1340/1877
Fax ++49(0)731-933-1855
e-mail: info@AEGID.de