Using The Power Supply And Data Cable Id 70212; Power Supply - AEG ARE I2 Installation Manual

Manual
Page 13 / 33- Revision 01
ARE I2 / RS 232 – Installation Guide

4.3.8 Using the Power Supply and Data Cable ID 70212

Using the Power Supply and Data Cable, no special assembly work inside of the SAB Cab has
be done by the customer. After making the link to a power supply and to the connector block
of Serial Data Port, the reader is ready to work.

power supply:

serial Interface:
RS 232
4.4 Power Supply
The device is designed for DC Current with an voltage in the range between 9. to .30V
minimum power of the power supply is 1.2 Watt. There no need to use special cable to supply
the device.
Attention!
The minimum voltage at the at the readers input mustn't be lower then 9V.
brown = + 9 ...30 Volt
white = Ground
green = RxD ( reader receives data's )
yellow = TxD ( reader sends data's )
grey = ground
DC
AEG
Identifikationssysteme GmbH
Söflinger Straße 100
D-89077 Ulm
Tel. ++49(0)731-933-1340/1877
Fax ++49(0)731-933-1855
e-mail: info@AEGID.de
. The