Network Identification - HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual

Table 4-3 TCP/IP Summary tab (continued)
Item
IPv4 status
Fully Qualified Domain Name (IPv4)
IPv4 Address
Config By
IPv6 Status
Fully Qualified Domain Name (IPv6)
IPv6 Address list
Default Route Information

Network Identification

This tab provides TCP/IP network identification . Items on this page are listed below.
Table 4-4 TCP/IP Network Identification tab
Item
Host Name
IPv4 Domain Name
IPv6 Domain Name
ENWW
Description
Indicates the status of IPv4 operation. IPv4 cannot be disabled from the embedded
Web server in this release.
The fully qualified domain name consists of the device's host name and domain name.
Identifies the IPv4 address, subnet mask and default gateway for the print server.
Specifies how the IPv4 parameters were configured: DHCP, BOOTP, Manual, or
Auto IP.
Indicates the status of IPv6 operation. IPv6 can be enabled or disabled throught the
embedded Web server.
The fully qualified domain name consists of the device's host name and domain
name. Depending on the network architecture, it can be the same as, or different
from, the IPv4 fully qualified domain name.
IPv6 addresses configured on the print server are listed. For each address, the
following items are specified:
■ Prefix length: identifies the number of bits that comprise the fixed portion of the
address. Typically, it is 64 and identifies network/subnet portion of the address.
■ Config By: identifies how the address was configured, such as auto-configuration
through link-local addressing, by a Router, by a DHCP(v6) server, or configured
manually.
■ Valid Lftm: The length of time (lifetime) that the address can be used, after which
the address becomes invalid. This value is determined during the auto-
configuration process.
■ Pref Lftm: The length of time (lifetime) that the address can be used without
limitation, but after which the address is deprecated — its use is discouraged.
The preferred lifetime is a subset of the valid lifetime. This value is determined
during the auto-configuration process.
If a router advertises itself to the print server as a default router on the local link, its
address and the length of time that it may be used are displayed.
Description
Specifies a readable IP name (the SNMP SysName object) for the network device.
The name must start with a letter and can end in a letter or number, up to 32 ASCII
characters. The default name is NPIxxxxxx, where xxxxxx are the last six digits of the
LAN hardware (MAC) address.
Specifies the name of the Domain Name System (DNS) domain that the HP Jetdirect
print server resides in (for example, support.hp.com). It does not include the host
name; it is not the Fully Qualified Domain Name (such as printer1.support.hp.com).
The IPv4 and IPv6 domain names may be the same or different depending on the
network.
Networking Tab 69