Using Bootp/Tftp (Ipv4); Why Use Bootp/Tftp - HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual

■ Embedded Web server. You can browse to the embedded Web server on the HP Jetdirect print
server to set configuration parameters. For more information, see
Server (V.31.xx).
■ Printer Control Panel. (For printers that support Jetdirect control panel menus) You can
manually enter the configuration data using the printer control panel keys. The control panel
method allows you to configure only a limited subset of configuration parameters. Therefore,
control panel configuration is recommended only during troubleshooting or for simple
installations. If control panel configuration is used, the print server saves the configuration when
powered off/on. For more information, see

Using BOOTP/TFTP (IPv4)

BOOTP (Bootstrap Protocol) and TFTP (Trivial File Transfer Protocol) provide a convenient way to
automatically configure the HP Jetdirect print server for TCP/IPv4 network operation. When powered
on, the Jetdirect print server sends a BOOTP request message onto the network. A properly
configured BOOTP server on the network will respond with a message that contains basic network
configuration data for the Jetdirect print server. The BOOTP server's response may also identify a file
that contains extended configuration data for the print server. The Jetdirect print server downloads
this file using TFTP. This TFTP configuration file may be located on the BOOTP server, or a
separate TFTP server.
BOOTP/TFTP servers are typically UNIX or Linux systems. Windows NT/2000/Server 2003 and
NetWare servers can respond to BOOTP requests. Windows NT/2000/Server 2003 servers are
configured through Microsoft DHCP services (see
Server 2003 systems may require third-party software for TFTP support. For setup of NetWare
BOOTP servers, refer to your NetWare documentation.
NOTE
subnets, IPv4 configuration may fail unless the routing device supports "BOOTP Relay"
(allows the transfer of BOOTP requests between subnets).

Why Use BOOTP/TFTP?

Using BOOTP/TFTP to download configuration data has the following benefits:
■ Enhanced configuration control of the HP Jetdirect print server. Configuration by other methods,
such as a printer control panel, are limited to select parameters.
■ Ease of configuration management. Network configuration parameters for the entire network can
be in one location.
■ Ease of HP Jetdirect print server configuration. Complete network configuration can be
automatically downloaded each time the print server is powered on.
NOTE
same when powered off/on. In DHCP, IP configuration parameters are leased and may
change over time.
When in its factory-default state and powered on, the HP Jetdirect print server will attempt to
automatically configure itself using several dynamic methods, one of which is BOOTP.
24 Chapter 3 TCP/IP Configuration
If the Jetdirect print server and BOOTP/DHCP server are located on different
BOOTP operation is similar to DHCP, but the resulting IP parameters will be the
"Using the Printer Control
Using DHCP (IPv4)). However, Windows NT/2000/
HP Jetdirect Embedded Web
Panel".
ENWW