HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual page 65

Table 3-3 Telnet Commands and Parameters (continued)
strict-8022
Other
upgrade
laa
1000t-pause-conf
link-type
ENWW
Controls DLC/LLC protocol interpretation:
0 (default): disables, that is, provides loose interpretation.
1: enables, that is, provides strict interpretation).
To configure one or more Jetdirect print servers with the name and location of a
firmware upgrade file.
CAUTION Ensure that command parameters are properly entered and that
the upgrade file is a higher version than the currently installed version. The
print server will attempt to upgrade when the upgrade file contains a higher
version than the installed version.
The command format is:
upgrade: <TFTP server IP> <Version> <Product Number> <Filename>
where,
<TFTP Server IP> is the IP address of the TFTP server, <Version> specifies the
firmware version of the upgrade file, <Product Number> specifies and must match
the product number of the print server, <Filename> is the path and filename of the
firmware upgrade file.
Specifies a locally administered address (LAA) that replaces the factory-assigned LAN
Hardware (MAC) address. If LAA is used, a user-specified string of exactly 12
hexadecimal digits must be entered.
For Ethernet print servers, the LAA address must start with hexadecimal X2, X6, XA, or
XE, where X is any hexadecimal digit 0 through F.
The default address is the factory-assigned address.
This command is used for flow control of inbound and outbound data.
OFF or 0: (Default) Flow control is disabled.
AUTO or 1: Flow control is configured through auto-negotiation with the network switch.
RCV or 2: Flow control is enabled only for data received from the network.
TRANS or 3: Flow control is enabled only for data transmitted to the network.
TXRX or 4: Flow control is enabled for both received and transmit data.
(For wired 10/100/1000T Ethernet) Sets the print server's link speed (10, 100, 1000
Mbps) and communication mode (Full- or Half-Duplex). The available link-speed
selections depend on the print server model. The selections that may be displayed are
listed below.
CAUTION If you change the link setting, network communications with the
print server and network device may be lost.
AUTO (default):
1000FULL: 1000 Mbps, full-duplex operation.
100AUTO: Limits auto-negotiation to a maximum link speed of 100 Mbps.
100FULL: 100 Mbps, full-duplex operation.
IPv4 Configuration 55