Using Telnet (Ipv4) - HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual

Jetdirect print servers
Hide thumbs Also See for 635n - JetDirect IPv6/IPsec Print Server:
Table of Contents

Advertisement

from which the configuration is made must be located on the same network segment as the HP
Jetdirect print server.
Using the arp and ping commands with HP Jetdirect print servers requires the following:
Windows NT/2000/XP/Server 2003 or UNIX system configured for TCP/IP operation
A legacy default IP address 192.0.0.192 has been set on the print server
The LAN hardware (MAC) address of the HP Jetdirect print server (specified on an HP Jetdirect
configuration page
NOTE
After an IP address is assigned through arp and ping commands, use other tools (such as Telnet,
embedded Web server, or HP Web Jetadmin software) to configure other IP parameters.
To configure a Jetdirect print server, use the following commands:
arp -s <IP address> <LAN hardware address>
ping <IP address>
where <IP address> is the desired IP address to be assigned to the print server. The arp
command writes the entries to the arp cache on the workstation, and the ping command configures
the IP address on the print server.
Depending on the system, the LAN hardware address may require a specific format.
For example:
For Windows NT 4.0, 2000, XP, Server 2003
arp -s 192.168.45.39
ping 192.168.45.39
For UNIX
arp -s 192.168.45.39
ping 192.168.45.39
NOTE
commands will be ignored. Once the IP address is configured, arp and ping cannot be used
unless the print server is reset to factory values (see
Server).
On UNIX systems, the arp -s command may vary between different systems.
Some BSD-based systems expect the IP address (or host name) in reverse order. Other
systems may require additional parameters. See your system documentation for specific
command formats.

Using Telnet (IPv4)

This section describes how to configure the print server using Telnet.
42
Chapter 3
TCP/IP Configuration
On some systems, superuser rights may be required for the arp command.
Once the IP address has been set on the print server, additional arp and ping
00-01-E6-a2-31-98
00:01:E6:a2:31:98
Troubleshooting the HP Jetdirect Print
ENWW

Advertisement

Table of Contents
loading

This manual is also suitable for:

635n

Table of Contents