Using Telnet To Erase The Existing Ip Settings; Moving To Another Network (Ipv4); Using The Embedded Web Server; Using The Printer Control Panel - HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual

Using Telnet to Erase the Existing IP Settings

To erase the IP address during a Telnet session, use the following command line entries:
1 Type cold-reset, then press Enter.
2 Type quit, then press
3 Power the print server off/on.
NOTE
Parameters for other subsystems such as IPX/SPX or AppleTalk are not affected.
To reset all parameters to factory default values, refer to
Print

Moving to Another Network (IPv4)

When moving an HP Jetdirect print server that is configured with an IP address to a new network,
make sure that the IP address does not conflict with addresses on the new network. You may
change the IP address of the print server to one that can be used on the new network, or erase the
current IP address and configure another address after it is installed on the new network. See
Troubleshooting the HP Jetdirect Print Server
default settings.
If the current BOOTP server is not reachable, you may need to locate a different BOOTP server and
configure the printer to this server.
If the print server was configured using BOOTP, DHCP or RARP, edit the appropriate system files
with updated settings. If the IP address was manually set (for example, from the printer control panel
or Telnet), reconfigure IP parameters as described in this chapter.

Using the Embedded Web Server

You can use the embedded Web server on the HP Jetdirect print server to configure or view IPv4
and IPv6 parameters. For more information, refer to

Using the Printer Control Panel

When supported by the printer, HP Jetdirect internal print servers provide a configuration menu that
can be accessed from the printer's control panel. Using this menu, you can enable or disable network
protocols and set basic network parameters.
NOTE
documentation.
In addition to configuration of IPv4 and other network protocols, HP Jetdirect 635n print
servers support the configuration of selected IPv6 and IPsec networking parameters through
the control panel.
58 Chapter 3 TCP/IP Configuration
Enter to exit Telnet.
This procedure resets all TCP/IP parameters, but only affects the TCP/IP subsystem.
Server.
For instructions on using the control panel for your printer, refer to your printer
Troubleshooting the HP Jetdirect
for instructions to reset the print server to factory
HP Jetdirect Embedded Web Server (V.31.xx).
ENWW