Installation Guide for the NETGEAR 54 Mbps Wireless PC Card WG511
How to Configure WEP Encryption Security
Following the steps below to perform this procedure.
connecting to an access point.
1. Run the WG511 Configuration Utility.
Make sure the WG511 software is installed and the WG511 is fully inserted in an available
a.
CardBus slot in your PC.
Open the configuration utility by clicking on the WG511 icon
b.
system tray.
Figure 3-7: Security tab page
Click on the Configuration tab to display the view shown above.
c.
2. Configure the Security settings.
Check the Enable Encryption check box.
a.
3-30
in the Windows
Configuration