How To Configure Wep Encryption Security - NETGEAR WG511T User Manual

User Manual for the NETGEAR 108 Mbps Wireless PC Card 32-bit CardBus WG511T
A Passphrase is used to automatically generate the WEP hexadecimal numbers for the key. If
the wireless network Access Point uses a Passphrase, you can also use that here. Otherwise,
you will have to manually enter the hexadecimal numbers.
WEP Hexadecimal Numbers: ______________________________
The WEP Hexadecimal Numbers are needed if a Passphrase is not used in the wireless
network access point, but rather if the key is manually entered.
Use the procedures below to configure basic security settings in the WG511T.

How to Configure WEP Encryption Security

Follow the steps below to configure WEP Encryption Security.
1. Run the WG511T Configuration Utility.
Figure 4-6: Settings tab page
4-10 Configuration