Table of Contents
Advertisement
Installation Guide for the NETGEAR 54 Mbps Wireless PC Card WG511
On the Windows taskbar click the Start button, and then click Run.
a.
Assuming the target PC is configured with 192.168.0.1 as its IP address, type
b.
192.168.0.1
This will cause a continuous ping to be sent to the device with the 192.168.0.1 static IP
c.
address. The ping response should change to "reply."
At this point the connection is established.
Note: If you cannot connect, please see the
for problems with accessing network resources, the Windows Client and File and Print
Sharing software might not be installed and configured properly on your computers. Please
refer
to."Preparing Your Computers for TCP/IP Networking" on page
Enabling Wireless Security Features
You can strengthen the security of your wireless connection by enabling Wired Equivalent Privacy
(WEP) encryption of the wireless data communications. For more information on 802.11 wireless
security, please see
"Authentication and WEP" on page
In addition to the WG511 wireless security features, you should also configure appropriate LAN
network security features such as requiring a user name and password to access the shared
resources in your network.
3-28
and then click OK.
"Basic Troubleshooting Tips" on page
B-36.
ping -t
2-20. Also,
C-43.
Configuration
Advertisement
Table of Contents
