Setting Up Wep Encryption Security - NETGEAR WG511T User Manual

Setting up WEP Encryption Security

Follow the steps below to configure WEP Encryption Security.
1. Run the WG511T Smart Wizard.
a. Make sure the WG511T software is installed and the WG511T is fully inserted in an
available CardBus slot in your laptop computer.
b. Use the
Figure 2-10
2. Configure the Security settings.
a. In the Profile box, select the profile or type in a profile name.
b. In the Network Name (SSID) field select the network, or enter the SSID.
Note: You will not get a wireless network connection unless the network SSID
matches exactly what is configured in the access point.
c. In the Security section, select WEP.
3. Select the WEP encryption strength you will use.
The choices are:
• 64-bit WEP data encryption
Network Connections and Wireless Security
NETGEAR 108 Mbps Wireless PC Card WG511T User Manual
icon to open the Smart Wizard. The Settings tab page opens.
v3.0, January 2007
2-13