Fence - Grizzly G0609 Owner's Manual

Fence

Make sure the fence, carriage, and table have
been thoroughly cleaned of all the export grease
before installing the fence, or the fence will not
slide easily. The fence has a keyway slot built into
the underside of it that fits over the key on the
table. These keep the fence perpendicular to the
cutterhead during adjustments.
The fence is heavy.
Seek assistance when
lifting it onto the jointer
stand.
Components and Hardware Needed:
Cap Screws M12-1.75 x 30 ............................... 2
Flat Washers 12mm .......................................... 3
Lock Washers 12mm ......................................... 2
Lock Nut M12-1.75 ............................................. 1
Fence Bracket ................................................... 1
Fence Assembly ................................................ 1
To install the fence:
1.
Align the mounting holes on the fence bracket
and jointer, and fasten with the M12-1.75 x 30
cap screws, flat washers and lock washers as
shown in Figure 8.
-16-
Figure 8. Installing fence bracket.
2. With the help of an assistant, lift the fence
assembly over the fence bracket, slip the
sliding bushing (Figure 9) into the fence
bracket slot, and make sure the key and key-
way slot fit snugly.
Qty
Key
Figure 9. Installing fence assembly.
3. Secure the sliding bushing with a 12mm flat
washer and lock nut.
Fence
Bracket Slot
Key Slot
Bushing
G0609 12" Parallelogram Jointer
Sliding