Stock Inspection And Requirements - Grizzly G0609 Owner's Manual

Table Movement: To move the infeed table,
loosen the table lock (Figure 17), move the table
with the table handwheel in the preset range,
then tighten the table lock. The outfeed table is
preset with no range of movement allowed, so
if it gets accidentally unlocked it will not move.
To adjust the preset range of movement, refer to
SECTION 7: SERVICE, Page 32 about setting
table heights.
Figure 17. Table control locations.
Fence Movement: The fence has a lock handle
that keeps it in position (Figure 18). To move the
fence, loosen the lock handle and slide the fence
where needed.
Fence Tilting: The tilt lock (Figure 18) secures
the fence at any position in the available range.
The stop block sets the fence tilt to 90°. Positive
stops stop the fence at 45° inward and 45° out-
ward, for common 45° bevel cuts. Even when the
fence is resting against the positive stops, the tilt
lock must be tightened before cutting.
Figure 18. Fence lock, tilt lock and stop block
locations.
-21-
G0609 12" Parallelogram Jointer