— If the pulleys are aligned, tighten the
motor mounts loosened in Step 1 and go
to Step 8.
— If the pulleys are NOT aligned, perform
Steps 6 & 7.
6. Remove the V-belts, loosen the set screws
on the end of the motor pulley, and align the
motor pulley with the cutterhead pulley.
7. Tighten the set screws, replace the V-belts,
and repeat Step 5.
8. Replace the access cover on the stand and
the V-belt cover on the jointer, as shown in
Figure 8.
Figure 8. V-belt guard installed.
-14-
V-Belt Guard
Installed
Fence Tilt Lever
Components and Hardware Needed:
Fence Tilt Lever ................................................. 1
Install the tilt lever where shown in Figure 9.
Figure 9. Tilt lever installation location.
Dust Port
Components and Hardware Needed:
Dust Port ........................................................... 1
Phillips Head Screws
1
Flat Washers
⁄
" ................................................ 4
1
4
Tools Needed:
Phillips Head Screwdriver ................................. 1
Install the dust port as shown in Figure 10.
Figure 10. Correctly installed dust port.
G0586 8" X 75" Deluxe Jointer
Qty
Tilt Lever
Installation
Location
Qty
⁄
"-20 x
⁄
" ...................... 4
3
4
8
Qty