Hitachi PC-ARF Technical Catalogue page 209

Hide thumbs Also See for PC-ARF:

Table of Contents

4 Individual remote controls

Receiver kit for wireless remote control

5 Draw the connection cable through the wiring hole of the indoor unit and run it across to the receiver kit installation

6 Install the air panel (optional) on the indoor unit.

7 Connect the receiver kit using the following procedure:

a. Pass the cable through the corner hole and connect

the connection cable and receiver kit wire. Once the

cable is connected, cover the connector with the

cover and secure it using a cable tie.

b. b. Hook the tab on the back of the receiver kit to the pin of the air panel, as

shown below.

c. c. Hook the L-shaped tab on the back of the receiver kit into the square hole

on the air panel and secure it with a screw.

8 Hook the other fixing tabs (3 positions) into the square holes of the air panel.

C A U T I O N

To remove the receiver kit after mounting the air panel:

Remove the screws  (4 positions) from the front of the air panel.

Move the receiver kit by hand in the direction indicated by the arrow  and remove the

tabs (2 positions) from the corner cover, then slide the receiver in the direction indicated

by the arrow .

TCGB0106 rev.0 - 12/2014

Connection cable

L-shaped tab

Corner access

Connection cable

Receiver kit

Tabs (2 positions)

Troubleshooting