Select An Apn To Use - NETGEAR Nighthawk M6 Pro User Manual

The APN page displays.
3. Specify the APN name.
The APN name is a label for display in the UI.
4. Specify the APN.
This step specifies the APN as defined by the carrier.
5. Change the PDP (data protocol), if necessary:
• IPV4
• IPV6
• IPV4V6
6. Change the PDP roaming protocol, if necessary:
• None
• IPV4
• IPV6
• IPV4V6
NOTE: PDP roaming protocol is the IP protocol used while you are roaming
(for example when you are traveling and the roaming network does not
support IPv6).
7. Select the network authentication mode:
• None
• PAP
• CHAP
• PAPCHAP
8. Enter the name and password, if they are required for the network.
9. Click or tap Add.
The entry is added to the table.

Select an APN to use

To select an APN to use:
1. From the web user interface dashboard, select Settings > Advanced > Cellular.
The Cellular page displays.
2. Select the Active radio button next to the APN entry.
The APN is selected.
Access the web user interface
Nighthawk M6 Pro, Nighthawk M6
72 User Manual