Factory Reset Your Mobile Hotspot From The Web User Interface; Enable Or Disable Ip Passthrough From The Web User Interface - NETGEAR Nighthawk M6 Pro User Manual

Factory reset your mobile hotspot
from the web user interface
To factory reset your mobile hotspot from the web user interface:
1. From the web user interface dashboard, select Settings > Administration > Factory
Reset.
The Factory Reset page displays.
2. Click or tap Factory Reset.
3. Click or tap Yes to confirm.
Your mobile hotspot resets and returns to its factory settings.
Enable or disable IP passthrough
from the web user interface
When IP passthrough is enabled, your mobile hotspot takes the IP address that your
cellular service provider assigned to your device and passes it through to a connected
device. Enabling IP passthrough allows you to configure the LTE subnet mask from the
web user interface, which might be necessary for some use cases.
To enable or disable IP passthrough from the web user interface:
1. From the web user interface dashboard, select Settings > Advanced > Mobile
Router Setup.
The Mobile Router Setup page displays.
2. Select the IP Passthrough On button to enable IP passthrough, or select the Off
button to disable it.
IP passthrough is disabled by default.
3. Click or tap Apply.
A message displays telling you that to save this change, your device must restart.
4. Click or tap Continue.
Your settings are saved.
Access the web user interface
Nighthawk M6 Pro, Nighthawk M6
69 User Manual