Assembling The Main Shaft - Husqvarna 701 Enduro 2017 Repair Manual

18 ENGINE
198
Check stop disks Q for damage and wear.
» If there is damage or wear:
- Change the stop disks.
Use new lock rings © with every repair.
18.4.37 Assembling the main shaft
Info
Use new lock rings with every repair.
I
Preparatory work
- Lubricate all parts carefully before assembling.
- Check the transmission. (S8 p. 196)
0
0
0 ©
0
©
0
0
©
0
©
0
I
©
o
-
0
0
0
0
©
ii
311922-10
Main work
- Secure the main shaft with the toothed end facing downward in the vise.
Guideline
Use soft jaws.
Mount needle bearing O-
Push on fifth-gear idler gear
0
with the shift dogs facing upward.
Mount stop disk
0
Position special tool
o
on the transmission shaft.
Mounting tool for lock ring (76629032000) (KS p. 328)
Position lock ring © on special tool
©
and push down with sleeve ©.
^ The lock ring engages in the groove of the transmission shaft.
Push on third/fourth-gear sliding gear
0
with the small gear wheel facing downward.
Position special tool
o
on the transmission shaft.
Mounting tool for lock ring (76629032000) (i! p. 328)