Changing The Swingarm Bearing - Husqvarna 701 Enduro 2017 Repair Manual

9 SHOCK ABSORBER, SWINGARM
69
Mount the new chain.
Rivet the chain, (il p. 114)
Position the engine sprocket cover.
Mount and tighten screw ©.
Guideline
0
■ j
2? i
Loctite® 243™ Screw, clutch slave cylin- M6x40 10 Nm
(7.4 Ibf ft)
i®
O
der
Mount and tighten screw
0
Guideline
R01421-11
25 Nm (18.4 Ibf ft) Remaining screws, chassis M8
Position the brake caliper in the guide.
D00782-10
Finishing work
- Install the rear wheel using a work stand. (SB p. 106)
- Check the chain tension. (SS p. 110)
- Remove the motorcycle from the work stand. (SS p. 12)
- Check the free travel of the foot brake lever. (SS p. 134)
Changing the swingarm bearing 9.28
Info
These operations are the same on both swingarm bearings.
I
Preparatory work
- Raise the motorcycle with the work stand. (SS p. 12)
- Remove the rear wheel using a work stand. (SS p. 105)
- Remove the swingarm. (SS p. 67)
Main work
- Remove collar bushings O-
O
a
\
O—-4
—o
D00774-10